Makes the toolbar look more comfortable instead of all squished
together, and more similar to our current look.
Instead of setting a hardcoded minimal size for buttons, MakeActions()
now uses the maximum size hint width.
* remove useless units after 'zero' values
* reduce the size of 'Dolphin' to be more reasonable and look better
* avoid hardcoding the normal and small font sizes
Just create the AboutDialog on the stack -- the actual object lives on
the heap anyway, since Qt uses the pimpl idiom. Removes the need for
an explicit new and a special delete on close attribute.
EmulationStateChanged is functionally correct right now, but
ConfigChanged expresses more semantically why the config setting gets
re-read and the widgets updated.
There are two special cases that the DSP accelerator handles in a
special way: when the end address is of the form xxxxxxx0 or
xxxxxxx1.
For these two cases, the normal overflow handling doesn't apply.
Instead, the overflow check is different, the ACCOV exception never
fires at all, the predscale register is not updated, reads are not
suspended, and if the end address is 16-byte aligned, the DSP loops
back to start_address + 1 instead of the regular start_address.
When an ACCOV is triggered, the accelerator stops reading back anything
and updating the current address until the YN2 register is set.
This is kept track of internally by the DSP; this state is not exposed
via any register.
However, we need to emulate this behaviour correctly because some
ucodes rely on it (notably AX GC); failure to emulate it will result
in reading past the end and start address for non-looped voices.
When the current address is xxxxxxxf, after doing the standard ADPCM
decoding and incrementing the current address as usual to get the
next address, the DSP will update the predscale register by reading
2 bytes from memory, and add two to get the next address.
This means xxxxxx10 cannot be a current address, as the DSP goes
from 0f to 12 directly.
A more serious issue with the old code is that if the start address
is 16-byte aligned, some samples will always be skipped, even when
that should not be the case.
An easy way to test whether this behaviour is correct is to check
the current address register and the predscale after each read.
Old code:
...
ACCA=00000002, predscale=<value>
ACCA=00000003, predscale=<value>
...
ACCA=0000000f, predscale=<value>
ACCA=00000010, predscale=<another value>
ACCA=00000013, predscale=<another value>
ACCA=00000014, predscale=<another value>
...
New code (and console):
...
ACCA=00000002, predscale=<value>
ACCA=00000003, predscale=<value>
...
ACCA=0000000f, predscale=<value>
ACCA=00000012, predscale=<another value>
ACCA=00000013, predscale=<another value>
...
Slightly cleaner, allows DSP accelerator behaviour to be
added to both HLE and LLE pretty easily, and makes the accelerator
easier to unit test.
I chose to include all accelerator state as private members, and
to expose state that is accessible via registers with getters/setters.
It's more verbose, yes, but it makes it very clear what is part of
the accelerator state and what isn't (e.g. coefs).
This works quite well for registers, since the accelerator can do
whatever it wants internally. For example, the start/end/current
addresses are masked -- having a getter/setter makes it easier to
enforce the mask.
This adds a test ucode that can be used to check the accelerator loop
behaviour with various start/end addresses.
It's actually more of a test template than a ready to use test.
